PREPARATION FOR USE

KICK GUARD® TO BAR INSTRUCTIONS

For saws with Kick Guard® P/N 2894901 and symmetrical or asymmetrical low-kick type guide bars.

1.Install bolt (A) in rear hole (B) of Kick Guard® and through front hole (C) in guide bar.

2.IMPORTANT: Dimple in Kick Guard® (D) must engage recess in guide bar (E).

3.Tighten nut (F) and bolt (A) until snug. Make certain Kick Guard® is flush against guide bar.

G

KH

J

I

WARNING DANGER

Saw Chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.

GUIDE BAR AND SAW CHAIN

•Remove two guide bar nuts (I) and remove sprocket guard

(J).

•Mount guide bar (G) on studs, and slide toward sprocket to make saw chain installation easier.

•Install saw chain (H) as shown, with cutters on top of guide bar facing forward.

IMPORTANT

Be certain tensioner (K) fits into lower adjuster hole before tightening guide bar nuts.

NOTE

Move chain brake lever fully rearward to install sprocket guard to saw.

•Install sprocket guard (J), and tighten guide bar nuts finger tight.

•Adjust saw chain tension, as instructed in “Adjustment, Chain Tension.”

7