Emission Data, Handling Fuel, Emission Control, Danger

DANGER

Fuel is VERY flammable. Use extreme care when mixing, storing or handling or serious personal injury may result.

•Use an approved fuel container.

•DO NOT smoke near fuel.

•DO NOT allow flames or sparks near fuel.

•Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.

•NEVER refuel a unit when the engine is HOT!

•NEVER refuel a unit with the engine running.

•DO NOT fill fuel tanks indoors.

ALWAYS fill fuel tanks outdoors over bare ground.

•Securely tighten fuel cap after refueling.

•Inspect for fuel leakage.

If fuel leakage is found, do not start or operate unit until leakage is repaired.

•Move at least 3 m (10 feet) from refueling location before starting the engine.

HANDLING FUEL

MIXING INSTRUCTIONS -

1.Fill an approved fuel container with half of the required amount of gasoline.

2.Add the proper amount of two-stroke oil to gasoline.

3.Close container and shake to mix oil with gasoline.

4.Add remaining gasoline, close fuel container, and remix.

IMPORTANT

•Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shut-off containers to reduce fuel spillage.

•Stored fuel ages.

Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is added.

•Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.

AFTER USE -

DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.

STORAGE -

Fuel storage laws vary by locality. Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, airtight container. Store in a well-ventilated, unoccupied building, away from sparks and flames.

EMISSION DATA

EMISSION CONTROL

(EXHAUST and EVAPORATIVE) EPA 2010 and/ or C.A.R.B. TIER III

The emission control system for the engine is EM/ TWC (Engine Modification and 3-way Catalyst) and for the fuel tank the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to California models only.

An Emission Control Label is located on the engine. (This is an example only, information on label varies by engine family).

PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)

The 300 hours emission compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual.

E M I S S I O N C O N T R O L I N F O R M A T I O N ENGINE FAMILY: #EHXS.0505RC DISPLACEMENT: 50.2cc EMISSION COMPLIANCE PERIOD: 300Hours

THIS ENGINE MEETS U.S.EPA EXH REGS FOR MODEL YEAR * * * *

REFER TO OWNER’S MANUAL FOR MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.

* * * ????