Kickback motion
Kickback
Chain brake function
When the lever is pushed forward, chain brake instantly work to stop the chain.
Chain brake release
When the lever is fully pulled, toward the operator, brake is released.
CHAIN BRAKE OPERATION
∙Set the lever in the released position before starting to cut.
∙If the brake is tripped by kick back reaction, the chain will stop immediately release the throttle to avoid possible damage prevent to the engine or clutch.
∙Do not attempt to operate the engine with the brake engaged.
TESTING THE BRAKE
∙Start the engine on a solid level surface and run at a fast idle until warm.
∙Hold the saw firmly by the handles and accelerate the engine to a fast idle.
∙Slowly operate the chain brake lever while holding the saw firmly on the ground.
When the brake lever trips, the chain should stop.
Immediately release the throttle trigger.
CAUTION
Do not allow the saw to tip forward in order to avoid damage to the chain.
If the chain does not stop immediately, return the saw to your authorized ECHO deafer for repair.
NOTE
∙For practice, while cutting a small tree, push the lever forward to engage the brake.
∙At all the time, confirm whether the brake works properly before each work.
∙If the chain brake is clogged with wood chips, function of the brake deteriorates a little. Always keep the device clean.
∙Do not increase engine revolution while the chain brake is engaged.
∙Chain brake is used in emergencies.
Do not use it unless absolutely necessary.
∙When in use of throttle lock at starting, keep the chain brake position.
And after starting the engine, release the brake immediately.
∙Never test the brake in an area where gasoline fumes are present.
15