25°

Keep this angle

Push file as shown

10°

Hold the file tipped 10° upward

1/5

One fifth of file diameter remains above cutter edge

Depth gauge tool

Remove until flat with tool

Round off the edge

SETTING SAW CHAIN

∙For setting saw chain, round file (4 mm dia. 5/32 inch) and flat file are used.

∙To keep correct position and correct angle, use the file holder (Sure Sharp).

-Round file (P-No. 897510-03931) and flat file (P-No. 897511-00230) are optional.

-Inquire about the file holder, if desired.

∙Place the depth gauge tool firmly on guide bar so that depth gauge protrudes.

Then file top of depth gauge with flat the file until flat with top of the depth gauge tool.

-Be sure to round off the front edge of the depth gauge.

21