OPERATION | |
|
|
Move stop switch (A) away from the STOP position.
2. Throttle Position Lever |
A
| Move throttle position lever (B) midway between idle and full | |
| throttle positions. |
|
3. | Choke |
|
| Move choke (C) to Cold Start ( | ) (closed) position. |
4. | Purge Bulb |
|
| Pump purge bulb (D) until fuel is visible and flows freely in the | |
| clear fuel tank return line. |
|
|
|
|
|
|
|
Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for starting. Do not allow the rope to snap back in. Always hold the unit firmly.
5.Recoil Starter
Place the unit on a flat, clear area. Firmly grasp throttle grip with left hand and rapidly pull recoil starter handle/rope (E) until engine fires , or maximum 5 pulls.
6.Choke
Move choke lever (C) to Run position, and if necessary, restart engine.
Note: If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 3 - 6.
7.Throttle Trigger
B
C
E
D
After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.
Note: Allow engine to warm up 3 minutes before use.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO NOT close the choke.
1.Stop Switch
Move stop switch (A) away from the STOP position.
2.Throttle Position Lever
Move throttle position lever (B) midway between idle and full throttle positions.
A
B
X7501182803 | 17 |
© 03/2013 ECHO Inc.
