HEDGE CLIPPER 21
OPERATOR'S MANUAL
SPARK PLUGLevel 2.
Tools required:
Parts required:
1.Remove spark plug and check for fouling, worn and rounded center electrode.
2.Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage engine.
3.Adjust spark plug gap by bending outer electrode.
4.Tighten spark plug to
Level 2.
Tools required: 3 mm Allen wrench, 4 mm Allen wrench, Pointed
Wood Stick, Cross head Screwdriver
Parts required: None if you are careful.
IMPORTANT
To maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area. This flow of air carries combustion heat away from the engine.
Overheating and engine seizure can occur when:
•Air intakes in the crankcase are blocked, preventing cooling air from reaching the cylinder.
•Dust and grass build up on the outside of the cylinder. This build up insulates the engine and prevents the heat from leaving.
Removal of crankcase cooling passage blockages or cleaning of cooling fins is considered “Normal Maintenance”. Any failure attributed to lack of maintenance is not warranted.