Echo HC-152 specifications Blades, Sharpening Level

MAINTENANCE HC-152

1.Clean dirt from the grease fitting (A).

2.Apply 1-2 pumps of grease into fitting, DO NOT over fill. Leave room for the grease to expand during operation

3.Wipe excess grease from around grease fitting.

Blades

A

Blades should only be removed and reinstalled by an Authorized ECHO Servicing Dealer, otherwise premature wear or internal damage may occur.

Sharpening

Level 2.

Parts Required: none

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands.

1.Move stop switch to stop position.

2.Disconnect spark plug wire.

3.Remove blade guard, if installed (see “Blade Guard Remove/Install instructions”).

4.Slide blades to allow file clearance using slots (A) on bottom of blade. Do not pry against cutting edges.

5.File each edge carefully. Follow the original shape of the blade.

If a power grinder is used DO NOT allow blade to over heat.

6.Install blade guard, if necessary (see “Blade Guard Remove/Install instructions”).

7.Lubricate blades (see “Lubrication”).

8.Connect spark plug wire.

A

6 mm (.25 in.) radius

45o

26 X7532249501

© 4/2013 ECHO Inc.