HEDGE CLIPPER 25

OPERATOR'S MANUAL

3.HI speed adjustment.

Adjust HI (A) needle with tachometer. Refer to Wide Open Throttle RPM settings listed in "Specifications" on page 12.

4.Check idle speed and reset if necessary. If tachometer is available, idle speed should be set to the specifications found on page 12 "Specifications" of this manual.

WARNING DANGER

When carburetor adjustment is completed, blades should not move at idle, otherwise serious personal injury may result.

LUBRICATION

Blades

Level 1.

Tools required: Clean rag, 25 or 50 mm (1 or 2 in.) medium bristle paint brush

Parts Required: 20W Engine Oil (lubrication), 50-50 mixture of kerosene and 20W oil (cleaning).

WARNING DANGER

Hedge Clipper Blades are very sharp. Wear gloves to protect hands.

1.Disconnect spark plug wire from spark plug.

2.Brush loose debris from blade and coat both sides of blade with the 50-50 cleaning mixture.

3.Allow cleaning mixture to soften the remaining gummy residue then wipe it from the blade.

4.Apply clean oil to the entire length of the blade. Be certain the blade bolts are lubricated.

5.Wipe excess oil from the blade before putting the unit back in service.