Echo HC-2410 HC-1500,Type 2E, HC-2400,2410 (All), BLADE STIFFENER REMOVE/INSTALL

HEDGE CLIPPER 27

OPERATOR'S MANUAL

HC-1500, Type 2E, HC-2400, 2410 (All)

Level 1.

Tools required: Grease Gun, Clean rag

Parts required: ECHO® LUBETM 8 oz. (P/N 91014) or Lithium Based

Grease.

1.Clean dirt from the grease fitting.

2.Carefully pump grease into fitting. DO NOT force grease. Too much pressure will force grease past seals and cause damage.

BLADE STIFFENER REMOVE/INSTALL

Level 2.

Tools required: (2) 13mm Open End

Parts Required: None

WARNING DANGER

Hedge Clipper blades are very sharp. Wear gloves to protect hands.

1. Disconnect spark plug wire from spark plug.

2. Hold blade bolt head under blade assembly. Remove blade locknut from top side turning counter clockwise.

3. Repeat step 2 for remaining blade nuts.

NOTE

Locking ability of Hedge Clipper blade nuts will diminish each time they are removed. Replace blade nuts if threading resistance is not felt when installing locknuts.