SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE |
|
| ||||
| A | |||||
The pump handle can be mounted on either side of the pump |
| |||||
shaft (A). To install the pump handle place the handle (C) over | C | |||||
|
| |||||
the shaft (A) aligning the pump handle hole and shaft hole. Push |
| B | ||||
the straight side of the cotter pin (B) through the aligned hole as |
| |||||
|
| |||||
shown in figure 1 thru 3. There are holes in the pump handle to |
|
| ||||
allow for either left(fig.4) or right (fig.5) hand mounting. |
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 1 | Figure 2 | |
Cotter Pin | Line up holes | |
|
|
|
|
|
|
Figure 4 | Figure 5 |
Left Hand | Right Hand |
STOWAWAY PUMP HANDLE
Pull |
| Rotate |
up |
| |
| 180º | |
|
| |
|
|
|
INSTALLING THE
SHOULDER STRAP
The top of the shoulder straps are attached to the tank. Attach the lower end of the straps by clipping the strap hooks to the metal frame between where the frame exits the tank and curves around.
3E
Figure 3
Slide pin through holes.
Pump Handle Positioned For Use (right hand shown)
Set into slot
WAND CLIP
The wand can be attached to the pump handle using the wand clip.
