INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump
shaft (A). To install the pump handle place the handle (C)
over the shaft (A) aligning the pump handle hole and shaft
hole. Slide the bolt (B) through the aligned hole as shown in
figure 1 thru 4. Tighten nut (D) to bolt. There are holes in the
pump handle to allow for either left(fig.4) or right (fig.5) hand
mounting.
3E
SPRAYER COMPONENTS & USE INFORMATION, Continued
Figure 1 Figure 2

Line up holes

Figure 3

Slide bolt through holes

Figure 5

Left Hand

Figure 6

Right Hand

Pump Handle
Positioned For Use
(right hand shown)

A

C

B

Figure 4

Tighten nut to bolt

Threaded Bolt
Nylon Lock Nut
D
O-ring
Wand
Retaining Nut Shut-off
Valve
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.