Echo PAS-225 manual nylon line head installation, to advance trimmer line, remove nylon line head

Pro Attachment SeriesTM 11

Operator's Manual

nylon line head installation

Parts Required: Nylon Line Head.

Caution

Wear Gloves or personal injury may result:

•Cutoff knife is sharp.

•Gearcase and surrounding area may be hot.

1.Be sure adapter plate (C) remains on PTO shaft (A).

2.Align locking hole in upper plate with notch in edge of gear hous- ing and insert head locking tool (D).

3.Thread line head (E) onto shaft by turning it counter-clockwise until head is tight against adapter plate (C).

4.Remove locking tool (D).

IMPORTANT

Semi-automatic nylon line heads must be used only with plastic debris shield with cut-off knife. Using nylon line heads with metal debris shield can result in trimmer damage, caused by operation with excessive line length.

D

A

C

D

E

to advance trimmer line

See Maintenance Section for nylon line replacement.

Tip:

To advance trimmer line, tap trimmer head against the ground while the head is turning at normal operating speed.

IMPORTANT

When the wear indicators located at the bottom of the Speed-Feed head are worn smooth, replacement of the cover or the entire Speed-Feed head is required.

Wear	Wear
	Indicators
Indicators

remove nylon line head

NOTE

Do not disassemble nylon line head.

1.Align locking hole in upper plate with notch in edge of gear hous- ing and insert head locking tool (D).

2.Remove line head (E) by turning it clockwise until head is com- pletely off of shaft.

3.Remove locking tool (D).

D

E