Pro Attachment SeriesTM 25
Operator's Manual
lubrication
Level 1.
Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or
Lithium Base Grease.
Gear Housing
1.Clean all loose debris from gear box.
2.Remove plug (A) and check level of grease.
3.Add grease if necessary. DO NOT
Drive Shaft (Lower)
(Trimmer Attachment Only)
IMPORTANT
Lower and upper drive shaft must be lubricated with high tem- perature automotive grease every 25 hours of operation, otherwise drive shaft assembly overheating and failure can result.
1.Loosen two (2) screws (B) and remove center locating screw (C). Pull gear box and shield from drive shaft housing.
2.Pull flexible cable from the drive shaft housing, wipe clean and
3.Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.
4.Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
A
C B
D