12 
Drive Shaft (Lower)
IMPORTANT
Lower and upper drive shaft must be lubricated with high tempera- ture automotive grease every 25 hours of operation, otherwise drive shaft assembly overheating and failure can result.
1.Loosen two (2) screws (B) and remove center locating screw (C). Pull gear box and shield from drive shaft housing.
2.Pull flexible cable from the drive shaft housing, wipe clean and
3.Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.
4.Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
NYLON LINE REPLACEMENT
Level1.
Parts Required: ECHO 0.095" Nylon Trimmer Line 6 m (20 ft.) long.
C
B
D
1.Shut engine off. Lay unit on the ground with head assembly up.
2.Hold drum (A) and firmly turn spool (B) CW (clockwise) until it disengages from the inner drive. Pull spool from drum. DO NOT push in on spool when turning.
B
A
A
B
