TRIMMER ATTACHMENT 9 OPERATOR'S MANUAL
5.Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation.
6.Secure lower shaft assembly to coupler by tightening clamping knob (D).
D
C
A
PLASTIC SHIELD INSTALLATION
(For Nylon Line Operation)
Tools Required: Screwdriver.
Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 16mm screws.
NOTE
The plastic shield is for use with the Nylon Line Head only. Install Metal Shield when using plastic or metal blades.
1.Place plastic shield on bottom of bearing housing flange.
2.Place shield plate on plastic shield, align holes. Install three (3) screws from bottom through plate and shield into gear case.
A
NYLON LINE HEAD INSTALLATION
(Use with Plastic Shield)
Tools Required: Head Locking Tool
Parts Required: Nylon Line Head.
1.Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool (C).
2.Remove vinyl protector from PTO shaft.
3.Be sure upper adaptor plate remains on PTO shaft (B).
4.Thread line head onto shaft by turning it counter clockwise until head is tight against upper plate (D).
5.Remove head locking tool.
C
B
D
C
