Echo PB-620 NOTE

CRUISE CONTROL KIT INSTALLATION INSTRUCTIONS

7.Place rear half of split clamp over spark plug lead, and press clamp on mounting screw boss in blower housing.

8.Place fuel/return lines in throttle cable/fuel line clamp (F):

•Place clear fuel return line in small recess

•Place black fuel line in large recess, in front of clear fuel return line

9.Adjust throttle cable nut position, and place nut in hex-shaped recess in clamp:

•Set cruise control button (S) to Wide Open Throttle position

•Pull down on throttle cable conduit until throttle plate on carburetor pivots to WOT position. Hold cable in position until throttle cable nut is adjusted and placed in clamp.

•Adjust throttle cable nut to align with recess in clamp, and place nut in clamp to hold WOT position.

•Place front half of split clamp over fuel lines and throttle cable, and secure with clamp screw.

NOTE

Make sure fuel lines and throttle cable are properly seated in clamp, and are not pinched during assembly

10.Place plastic cable tie (G) around fuel lines and throttle cable, but do not draw tight. Carefully cut off excess end of cable tie.

11.Gather ignition leads around coupler, and secure coupler to spark plug lead and throttle cable with cable tie. Trim excess end of cable tie.