10

throttle linkage and ignition leads

1.Connect ignition stop leads (A) and (B).

2.Place throttle linkage (C) through adjustment fixture (D) and install wire end into large carburetor throttle swivel hole (E). Check throttle for freedom of movement and that wide open throttle / low idle extremes are adjusted properly. The throttle linkage must be adjusted by moving the adjustment fixture (D). Consult with your

Echo Dealer for correct adjustment procedure.

3.Bundle and secure ignition leads against engine housing with clip

(F).

A B

C

DE

F

front handle

Tools Required: Cross-Head Screwdriver

Parts Required: Front Handle, Lower Bracket, 4 - 5x35 mm screws

NOTE

Label shows minimum spacing for front handle location.

1.Assemble front handle and bracket loosely to drive shaft.

2.Position front handle in comfortable operating position and tighten screws.

MIN

SPACING