
10
Contents
The ECHO product you purchased has been factory
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.
___ 1, | Power Head |
___ 1, Drive Shaft Assembly | |
___ 1, Plastic Bag | |
___ 1, | Operator's Manual |
___ 1, | Safety Manual |
___ 1, Warranty Registration Card | |
___ 1, | Front Handle |
___ 1, Lower Bracket, Front Handle | |
___ 4, | 5 x 35 mm screws |
___ 1, | |
___ 1, | Torx T27 |
___ 2, | Split pin |
___ 1, 4 mm Hexagon Wrench | |
___ 1, | Locking Tool |
___ 1, | 8 x 10 mm Spanner Wrench |
___ 1, | Safety Glasses |
Assembly
Tools Required: 4 mm Hex Wrench, 8 x 10 mm
Parts Required: Power head, Drive Shaft Assembly
drive shaft/power head
1.Stand power head upright on a level surface.
2.Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft clamp, and remove center drive shaft location bolt (A).
3.Remove dust cap and carefully fit drive shaft assembly to engine making sure that inner drive shaft engages into clutch mount.
4.Turn drive shaft housing until locating hole lines up with location hole in clamp and install center drive shaft location bolt (A).
NOTE
Gear Housing must be aligned properly with engine. Aligning center locating hole in driveshaft housing with center drive shaft bolt
(A) provides correct alignment.
BB
A