Power Edger

23

Operator's Manual

drive shaft lubrication

Level 1.

Tools required: 8 mm Open End Wrench, Torx T27 L-Wrench (PE-265S), 4mm Hex Wrench (PE-265),

 

Clean rag

 

 

 

 

 

Parts Required:

POWER BLENDXTM 8 oz. (P/N 91014) or Lithium

PE-265

A

 

 

 

 

Base Grease.

 

 

1.Loosen two (2) screws (A) and remove center locating screw (B). Pull gear box and shield from drive shaft housing.

2.Pull flexible cable from the drive shaft housing, wipe clean and

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

B

3.Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.

4. Install the gear housing and shield assembly.

PE-265S

A

 

B

blade replacement/lubrication

Level 1.

Tools Required: T-wrench, Locking Tool, Needle Nose Pliers, 13 mm Open End Wrench

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Base Grease, Blade P/N 69601552632, split pin P/N 90030020022

NOTE

Grease gear case every 15 - 25 hours of use. Replace blade when it is worn shorter than 6 inches. Remove blade and adapters before greasing to prevent damage to gear and bearings.

1.Shut engine off. Disconnect spark plug lead from spark plug.