22

Drive Shaft Assembly

Level 1.

NOTE

Hedge Clipper drive shaft should be greased every 25 hours of operation.

Tools required: Torx T27 L-Wrench, screwdriver, clean rag, small brush

Parts required: POWER BLENDXTM 14 oz. cartridge or Lithium Based Grease

WARNING

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands.

1.Remove gear housing locating screw (A) and clamping screw (B). Remove the gear housing assembly from the drive shaft housing.

2.Pull the drive shaft (C) from the housing, wipe clean and re-coat with a thin coating [1/2 oz. (15 ml)] of grease.

3.Slide the drive shaft back in the drive housing being careful not to get dirt on the flex shaft.

4.Install the gear housing assembly.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

sharpening blades

Level 2.

Tools required: Flat file, screwdriver

Parts required: None

WARNING

A

BD

C

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands.