Grass Trimmer/Brush Cutter 13

Operator's Manual

u-handle installation

Tools Required:

17 & 19 mm wrench, 4 mm hex socket wrench

 

Parts Required:

U-Handle, Clamp w/screws, 8 mm x 55 mm hex

 

A

 

bolt,

 

B

 

8 mm flat washer

 

 

1.Install upper U-Handle and bracket on lower bracket with one

(1) 8mm x 55mm bolt (A) and (1) large circular washer. Do not tighten bolt securely until final adjustments are completed.

2.Loosen upper (2) U-handle clamp screws (B), and position U- handle as shown.

3.Lightly tighten 8mm bolt (A) and clamp screws (B) to hold U- handle in position until final adjustments are completed.

4.Route throttle linkage and ignition lead assembly along shaft and clip as shown.

5. Install throttle linkage cable into fan cover clip (C).

C

throttle linkage and ignition leads

1.

Close choke and remove air filter cover.

2.

Place throttle linkage (A) through adjustment fixture (B) and install

A

wire end into large carburetor throttle swivel hole (C). Check

throttle for freedom of movement and that wide open throttle / low

idle extremes are adjusted properly. The throttle linkage must be

adjusted by moving the adjustment fixture (B). Consult with your

Echo Dealer for correct adjustment procedure.

3. Connect 2 ignition stop leads (D,E) from throttle cable tubing to 2

ignition leads (D,E) on engine.

B

D

C

EF