Grass Trimmer/Brush Cutter 27

Operator's Manual

lubrication

Level 1.

Tools Required: 13 mm Open End Wrench, Screwdriver, Clean Rag.

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium

Base Grease.

Gear Housing

1.

Clean all loose debris from gear box.

 

 

2.

Remove plug (A) and check level of grease.

A A

3.Add grease if necessary, DO NOT over-fill.

Drive Shaft

1. Loosen two (2) screws (B) and remove center locating screw (C).

C

Pull gear box and shield from drive shaft housing.

B

2.Pull flexible cable from the drive shaft housing, wipe clean and recoat with a thin coating[15 ml (1/2 oz.)] of grease.

3.

Slide the flexible cable back in the drive housing. DO NOT get

B

 

 

dirt on the flex cable.

 

4.

Install the gear housing and shield assembly.

D

 

 

 

 

 

IMPORTANT

 

 

 

 

 

Flat edge of washers (D) must be against drive shaft.