ASSEMBLY | |
|
|
To Advance Trimmer Line
See Maintenance Section for nylon line replacement.
Note: To advance trimmer line, tap trimmer head against the ground while the head is turning at normal operating speed.
Remove Nylon Line Head
Note: Do not disassemble nylon line head.
1.Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool (D).
2.Remove line head (E) by turning it clockwise until head is completely off of shaft.
3.Remove locking tool (D).
Support Handle Installation
Note: Label shows minimum spacing for support handle location.
1.If necessary, position support handle for comfortable operation and securely tighten screws.
D
E
MIN
SPACING
X7502026004 | 15 |
© 9/2014 ECHO Inc.