Echo SRM-266/S Operation, Lay the unit on a flat area and keep movable attachment parts

OPERATION SRM-266/S

Move stop switch (A) away from the STOP position.

A

2.	Choke
	Move choke lever (B) to Cold Start Position (		).
3.	Purge Bulb			B
	Pump purge bulb (C) until fuel is visible and flows freely in the
	clear fuel tank return line. Pump bulb an additional 4 or 5
	times.
				C
				D
4.	Recoil Starter
	Lay the unit on a flat area and keep movable attachment parts
	clear of all obstacles. Firmly grasp throttle handle and throttle
	trigger lockout with left hand and fully depress throttle trigger
	to wide open position. Rapidly pull recoil starter handle/rope
	(D) until engine fires (or maximum five [5] pulls).
5.	Choke
	After engine fires (or 5 pulls), move choke (B) to the Run			D
	(	) (open) position. Firmly grasp throttle handle and throttle
	trigger lockout with left hand and fully depress throttle trigger
	to wide open position. Pull starter handle/rope until engine
	starts and runs. Release throttle trigger and allow unit to warm up at idle for several minutes.

Note: If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5.

6.Throttle Trigger

After engine warm-up, grip the throttle handle and support handle. Depress the throttle trigger lockout, and gradually depress throttle trigger to increase engine RPM to operating speed.

20 X7502026004

© 9/2014 ECHO Inc.