Grass Trimmer/Brush Cutter 11 Operator's Manual
1.Align hole in upper plate (D) with notch in gear housing (E), and insert locking tool to prevent splined shaft from turning. Arrow on gear housing flange points to notch location.
2.Remove split pin (F), L.H. blade nut (G), lower plate (H), and up- per plate (D) from PTO shaft. Turn blade nut clockwise to remove.
3.Remove locking tool.
4.Loosely attach bracket (I) to shield (J) and attach shield to bottom of gear housing (E) with hardware provided.
5.Tighten all shield hardware.
Install Blade
Tools Required: Locking Tool, 17x19 mm Wrench.
Parts Required: Upper Plat, Lower Plate, 10 mm Nut w/L.H. threads, 2 x 25 mm Cotter Pin, Blade.
1.Install upper plate (D) on splined PTO shaft, pilot side down. Blade installation requires Upper Plate (D).
2.Install Blade (K) on upper plate pilot. Blades must be installed so that rotation arrow on blade matches rotation of unit: teeth toward direction of rotation (See debris shield decal). Secure blade with Lower Plate (H), and 10 mm L.H. nut (G). Turn nut
3.Align hole in upper plate with notch in gear housing, and insert Locking Tool (L) to prevent splined shaft from turning. Arrow on gear housing points to notch. Tighten 10 mm nut securely.
4.Insert Cotter Pin (F) in hole in PTO shaft, and bend pin legs around shaft counterclockwise to retain 10 mm nut.
IMPORTANT
Never reuse a cotter pin - install a new cotter pin each time a blade is installed or replaced.
5.Remove locking tool.
E
D 
H G 
F
E
I
J
D
L
K
H
G
F
DL
20
K
H
GF
