20 
starting cold engine
WARNING
When engine is started, confirm that there is not any abnormal vibration or sound. If there is abnormal vibration or sound, ask your DEALER to repair. After refueling tighten fuel cap firmly and check for leakage. In case of fuel leakage repair before starting operation since there is a danger of fire.
1.Stop Switch
Move stop switch button (A) forward away from the STOP posi- tion.
2.Choke
Move choke lever (B) to Cold Start Position (
).
3.Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4.Press the decompression device (E).
5.Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Hold unit firmly, and rapidly pull recoil starter handle/rope (D) until engine fires (or maximum five [5] pulls).
NOTE
Starter handle : Use short pulls - only 1/2 - 2/3 of starter rope for starting. Do not let starter rope snap back in.
Always hold the unit firmly.
6.Choke
After engine fires (or 5 pulls), move choke lever back to Run
(
) position. Pull recoil starter starter handle/rope until engine starts and runs. Allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5.
7.Throttle Trigger
After engine
A
B |
|
C | D |
E |
|
D
