10
ASSEMBLY
DRIVE SHAFT/POWER HEAD
Tools Required: 4 mm Hex Wrench
Parts Required: Power Head, Drive Shaft Assembly
1. | Stand power head upright on a level surface. |
|
2. | Loosen the drive shaft clamp bolt (A) at engine drive shaft clamp, | B |
| and remove drive shaft locating bolt (B). | |
|
| |
3. | Remove protective plastic cap from end of drive shaft assembly. |
|
| Carefully fit driveshaft assembly to engine making sure that |
|
| inner drive shaft engages clutch mount. |
|
4. | Turn drive shaft housing until locating hole lines up with locating |
|
| hole in clamp and install drive shaft locating bolt (B). | A |
|
|
|
| NOTE |
|
| Gear housing must be aligned properly with engine. Aligning center |
|
| locating hole in driveshaft housing with center drive shaft bolt (B) |
|
| provides correct alignment. |
|
|
|
|
5.Tighten drive shaft clamp bolt (A) securely.
WARNING
Never start engine without driveshaft assembly installed.
This could result in serious injury.
BLADE INSTALLATION
WARNING
You must install the
Install Metal Shield
Tools Required: 8 x 10 mm
Parts Required: Metal Shield, Shield Bracket,
3 - 5 x 10 mm screws (metal shield to gear housing).
2 - 5 x 10 mm screws, 2 - 5 mm nuts (bracket to shield).
2 - 5 mm nuts (bracket to gear housing).