Water PumP
OPeratOr's manual 19
NOTE
The throttle cable remains assembled to the engine cover and the
spark plug lead and grommet remain installed.
IMPORTANT
DO NOT use a metal scraper to remove dirt from the cylinder ns.
3. Use the brush to remove dirt from the cylinder ns.
4. Remove grass and leaves from the grid between the starter and fuel
tank.
5. When installing the cover, be certain the tab of the metal deector
shield is in the slot of the cover.

eXhausT sysTem

Spark Arrestor Screen

Level2.
Parts Required: Spark Arrestor Screen, Gasket
1. Remove engine cover. See “Cleaning Cooling System” for step by
step instructions.
2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
3. Remove screen cover (A), screen holder (B), gasket (C), and spark
arrestor screen (D) from mufer body.
4. Clean carbon deposits from screen (D) and mufer components.
5. Replace screen if it is cracked, plugged or has holes burned
through.
6. Install spark arrestor screen, gaskets, and cover.
A
B
C
D