18 
spark plug
Level 2.
Parts Required: REPOWERTM
1.Remove spark plug and check for fouling, worn and rounded cen- ter electrode.
2.Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage engine.
3.Adjust spark plug gap by bending outer electrode.
4.Tighten spark plug to
0.65 mm 
(0.026 in.)
cooling system
Level 2.
Parts Required: None.
IMPORTANT
To maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area. This flow of air carries combustion heat away from the engine.
Overheating and engine seizure can occur when:
•Air intakes are blocked, preventing cooling air from reaching the cylinder.
•Dust and grass build up on the outside of the cylinder. This build up insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages or cleaning of cooling fins is considered “Normal Maintenance”. Any failure attributed to lack of maintenance is not warranted.
1.Remove spark plug lead and throttle cable end from the carburetor swivel.
2.Remove the four screws that retain the engine cover. Two at the top of the starter, two on either side of the front. Lift the cover from the engine and lay to the front of the pump.
