Eclipse - Fujitsu Ten CD2000 manual How to operate the tuner, Tuning to a station

Operation

How to operate the tuner

ATTENTION

•If stations have been stored in memory, pressing the stored button from [1] to [6] will directly select a station. (Refer to "Manually setting stations into memory" on page 21)

CAUTION

If the vehicle’s battery is disconnected (for repairs to the vehicle or for removing the receiver), all stations in memory will be lost. In such a case, set stations in the memory again.

Tuning to a station

First, press the [FM AM] button to start tuner operation.

There are automatic and manual methods for setting stations in memory. The receiver will accept up to 24 stations in memory: 6 in AM 18 in FM (6 each for FM1, FM2 and FM3.) (Initial setting)

3 Press the [ ] or [ ] button to start the automatic station search.

[ ] button:

Starts searching toward higher frequencies.

[ ] button:

Starts searching toward lower frequencies.

ATTENTION

At times, it may be difficult to maintain optimum reception because the antenna affixed to your vehicle is in motion constantly (relative to the broadcast antenna), encountering continuous variation in the received radio signals’ strength. Other factors affecting reception include interference from natural obstacles, sign posts, etc.

When an optional HD Radio tuner unit is connected, digital broadcasts have reception priority. (U.S.A. only)

Press the [FM AM] button for less

1 than one second to switch to the desired FM, AM bands.

Radio bands will switch from FM1 ➔ FM2 ➔ FM3 ➔ AM in order each time the button is pressed.

2	Turn the [SEL] button to the left or
	right to tune to a station.

Turn to the right:

Tunes to higher frequencies.

Turn to the left:

Tunes to lower frequencies.

20