Eclipse - Fujitsu Ten CD5000 English English, 4Mount the stud bolt and bushing to the main unit

English

English

4Mount the stud bolt and bushing to the main unit.

5Insert the main unit into the mounting sleeve until it locks in place.

6Fasten the rear of the main unit.

7Install the bezel on the main unit.

Tip

•Be careful not to forcefully push on the main unit's display or buttons during installation. This may result in damage to the main unit.

•This installation method is only one example. When installing the main unit to the vehicle, be sure to ask the place of purchase for information on the installation method used.

Metal of vehicle

Dashboard or console box

9 Bushing

8 Stud bolt

3 Mounting sleeve

5Bezel

- Mounting the main unit (If installing the main unit using the side brackets of the vehicle) -

Tip

•Carefully bind any excess length of wire that is connected to the main unit and secure it to an area of empty space in the vehicle so that it does not dislodge or interfere with the main unit or vehicle-side equipment. If the wires are not handled correctly, operating problems or short-circuits may occur, and this may result in the danger of fire or other accidents.

•Connect all wires before installing the main unit.

1Remove the pocket and any other accessories from the center cluster to make room for the main unit.

Center cluster panel

Pocket, etc

Mounting bolts

Español Français Italiano

2Remove the mounting brackets for the pocket.

3Attach the brackets to the main unit.

1 Main unit

Tip
Be sure to use the supplied accessory mounting
screws (Red:M5 x 8) as the mounting screws. If	6	Hex-head bolt
any other screws are used, they may damage the
		(Red:M5 x 8) x 4

inside of the main unit.

Nederlands Svenska

4Install the main unit in the vehicle.

Tip

•Be careful not to forcefully push on the main unit's display or buttons during installation. This may result in damage to the main unit.

•This installation method is only one example. When installing the main unit to the vehicle, be sure to ask the place of purchase for information on the installation method used.

	Screw
	x 4
Pocket
	Mounting bracket
6 Hex-head bolt	7 Flat head
(Red:M5 x 8) x 4	screw
	(Red:M5x8) x 4

Select the screws in accordance with the shapes of the screw holes in the mounting bracket.

- 12 -