Installing the main unit

- Installation angle -

Tip

Front

 

To maintain proper function, the unit must be mounted at less than 30 degrees. If the angle is in excess of 30 degrees, CD skipping or ejection may occur.

30˚ or less

Level (reference)

- Main unit installation example (If installing the main unit using the mounting sleeve) -

English Deutsch

Tip

•Carefully bind any excess length of cord that is connected to the main unit and secure it to an area of empty space in the vehicle so that it does not move around or get caught in the main unit or vehicle-side equipment. If the cords are not handled correctly, operating problems or short- circuits may occur, and this may result in the danger of fire or other accidents.

•Connect all cables before installing the main unit.

Dashboard or console box

Bend the mounting

 

tabs.

3 Mounting sleeve

Français Español

1Insert the mounting sleeve into the opening in the vehicle dashboard or console box.

2Use a screwdriver or the like to bend the tabs in the mounting sleeve to secure the mounting sleeve.

3Attach the side brackets to the main unit using flathead screws.

Tip

Be sure to use the supplied accessory mounting screws (Red:M5 x 8) as the mounting screws. If any other screws are used, they may damage the inside of the unit.

4Mount the stud bolt to the main unit.

5Insert the main unit into the mounting sleeve until it locks in place.

6Fasten the rear of the main unit.

7Install the bezel on the main unit.

Tip

•Be careful not to forcefully push on the main unit's display or buttons during installation. This may result in damage to the main unit.

•This installation method is only one example. When installing the main unit to the vehicle, be sure to as the place of purchase for information on what installation method to use.

1 Main unit

7 Flat head screws (Red:M5 x 8) x 2

4 Side brackets

Metal of vehicle

Dashboard or console box

9 Bushing

8 Stud bolt

3 Mounting sleeve

5 Bezel

Svenska Nederlands Italiano

- 7 -