Eddie Bauer 22-750 manual Shown installed, Seat and buckles, place, Your child in the child, Age

4358-3410D Alpha 5pt	1/26/06
4
NOTE: Locking clip is
shown installed.

11:39 AM Page 39

With weakest hand at belt path, tilt and push the child restraint forward and back, and from side to side. If the seat belts do not loosen, your child restraint should be secure.

NOTE: Some “play” from front to back or about an inch from side to side is acceptable. If it moves more, review “Knowing Your Vehicle Belts” and “The Locking Clip” sections.

1

2

NOTE: Do not use LATCH system along with the adult lap or lap/shoulder belt.

Route LATCH belt through upper slot in side of shell.

Pull one LATCH hook across the back and out the other side.

Forward-Facing Use: 22-40 lbs. (10.1-18

!WARNING

Using this child restraint in any vehicle seat where the lap belt cannot be tightened securely and properly or where it can be loosened by pulling on it, can result in serious injury or death.

5	After checking for hot
	seat and buckles, place
	your child in the child
	restraint as described in
	the “Securing Your Child in
	the Child Restraint”

3

The LATCH adjuster can be on either side, but the belt should not be twisted.

Place child restraint flush against the back of the vehicle seat forward- facing in the back seat.

The recline position is to be used only to install the child restraint flush against the back of the vehicle seat back, if needed.

kg), 34-43” (85.1-110 cm), Over 1 year of

section.

4

Fasten one LATCH belt hook to the anchor in the vehicle seat located in the vehicle seat bight. Repeat for other side of child restraint. See your vehicle owner’s manual for locations and more information.

age.

36 37 continued on next page.