Eddie Bauer 4358-3432E, Enspira Adjusting the Top Anchorage Strap, Belt-Positioning Booster Use

4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 45

Adjusting the Top Anchorage Strap

The top anchorage strap (tether) is used for the forward- facing position only.

Most vehicles made after 9/1/99 already have the anchor hardware for a top anchorage strap. Refer to your owner’s manual or call your dealer.

Storage of Top Anchorage Strap:

Rear-Facing position: Place top anchorage strap over the back of the child restraint with the anchor hook secured under the child restraint.

Belt-Positioning Booster position: Place top anchorage strap behind the seat with the anchor hook under the seat.

To Attach Top Anchorage Strap: Put knee in child restraint and push down; attach hook to anchor in vehicle.

Pull loose	To Adjust Top
	Anchorage Strap:
end to
	To tighten; pull on free
tighten
	end of top anchorage
	strap.

Belt-Positioning Booster Use

Refer to the “Choosing Restraint and Position” section to make sure your child is at the proper weight and height to use the belt- positioning booster.

Lap/Shoulder Belt

Do not use LATCH when using the belt- positioning booster.

You MUST fasten the LATCH belt hooks on side of child restraint as shown.

When your child is over 40 lbs. (18.1 kg) or 43” (110.1 cm) and over 1 year old, you must remove the harness and use this seat as a belt- positioning booster.

Belt-Positioning Booster Use: 40-80 lbs. (18.1-36.3 kg), 43-52” (110.1-132.1 cm), Over 1 year

Lift up to

loosen

To loosen; lift up on top anchorage lock and push lock toward top anchorage hook.

!WARNING

A loose LATCH system can result in serious injury or death.

of age.

42 43