Eddie Bauer Enspira, 4358-3432E manual For Models With a Body Pillow, Check Harness Height

4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 15

4

Press on harness retainer release button and pull apart.

8

1

2

3

Determine which of the three available buckle slots is both comfortable and snug. Refer to “Removal of Harness” to adjust buckle.

NOTE: You must use the 1st and 2nd crotch strap slots rear-facing. The 3rd slot is for forward-facing

5	Press red button on
	buckle to release the
	buckle plates. Place
	harness over sides of child

only.

restraint.

6	Lift headrest to the highest
	position by pulling headrest
	out while sliding up. This
	will expose all harness
	slots.

9

Harness

Guide

just above the shoulders.

Check Harness Height

Rear-Facing Position: Harness guide must be even with or just below

the shoulders.

Forward-Facing Position: Harness guide must be even with or

7	Place the child’s bottom
	and back flat against the
	child restraint.This will
	increase comfort and allow
	the harness to properly
	tighten.

If the harness guide is below the child’s shoulders in the highest

harness location and the child weighs at least 40 lbs. (18.1 kg) and is over 1 year old, convert the seat to a belt-positioning booster.

For Models With A Body Pillow

10	Determine which set of
	harness guide slots works
	best for your child. Adjust if
	needed.

12 13 continued on next page.