![](/images/new-backgrounds/1231987/23198741x1.webp)
4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 41
With knee still in child restraint, attach hook to anchor in vehicle. Push down firmly and tighten
Forward-
top anchorage strap.
1 |
NOTE: Do not use
Facing
To adjust top anchorage strap: See “Adjusting Top Anchorage Strap” section.
NOTE: If your vehicle does not have an anchor bracket, tuck the top anchorage strap’s hook under the child restraint.
LATCH system along with the adult lap or lap/shoulder belt.
Route LATCH belt through upper slot in side
Use:
5 |
NOTE: Locking clip is |
shown installed. |
With weakest hand at belt path, tilt and push the child restraint forward and back, and from side to side. If the seat belts do not loosen, your child restraint should be secure.
NOTE: Some “play” from front to back or about an inch from side to side is acceptable. If it moves more, review “Knowing Your Vehicle Belts” and “The Locking Clip” sections.
2 |
of shell.
Pull one LATCH hook across the back and out the other side.
The LATCH adjuster can be on either side, but the belt should not be twisted.
lbs.
!WARNING
Using this child restraint in any vehicle seat where the lap belt cannot be tightened securely and properly or where it can be loosened by pulling on it, can result in serious injury or death.
6 | After checking for hot seat |
and buckles, place your | |
| child in the child restraint |
| as described in the |
| “Securing Your Child in the |
| Child Restraint” section. |
3
Connect and tighten harness straps prior to installing in vehicle.
Place child restraint flush against the back of the vehicle seat
forward-facing in the back seat.
The recline position is to be used only to install the child restraint flush against the back of the vehicle seat back, if needed.
1 year of age.
38 | 39 | continued on next page. |