Installing the Ice Maker
The ice maker should be installed by a licensed plumber to be in accordance with local electrical and plumbing code requirements.
Before you plug the ice maker in to a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor’s oils to settle.
Unpacking the Ice Maker
WARNING: Use two more people to move and install the ice maker. Failure to do so can result in back or other injury.
Carefully remove the packaging materials. Remove any shipping tape and glue from your ice maker before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your icemaker. IMPORTANT: Do not remove any safety, warning, or product information labels from your ice maker.
Types of Installation
This ice maker has been designed for
Free-standing installation:
A
Recessed installation:
A recessed installation will allow you to install the ice maker under a counter or in a kitchen cabinet provided the required clearance space around the ice maker is followed. This installation has the same requirements as a
Built-in installation:
It is necessary to allow adequate ventilation space around the unit (make sure there is at least some ventilation room for the back of the unit). The following additional items must be observed.
1.Place the ice maker in front of the installation location. Remove the feet and place the unit flat on the floor or on a platform depending on your installation requirements.
2.The water supply pipe must be plumbed before connecting to the ice maker. Install the drain line into your drain.
3.Turn on main water supply and tap. Check for water supply connection leaks. Tighten any connections (including connections at the
4.If the electrical outlet for the ice maker is behind the cabinet, plug in the ice maker.
5.Push the ice maker into position.
6.Seal all around the cabinet to the floor with an approved caulking compound.
3
