Installation sheet
Tools needed for Installation
• Multi wrench
• Utility Knife
• Channel Lock
• Nut driver
• Level
• Screw driver - Flat Blade
Parts supplied for installation.
Inlet Water Hose - One Washers - Two
Electrical
Refer to serial plate for specific electrical requirements
Water
Washer dryer needs one standard 3/4 inch water supply faucet with a pressure between 30 to 120 pounds per square inch
Cabinet Dimensions
inch |
C |
Height33.46 |
Operation Of A Condensing Dryer
The washer dryer combo offers many improvements in this method of drying. The condensing chamber (b) is located outside of the tub assembly, reducing the amount of heat
to overcome. This allows for more cooling of the circulated air.
The air inside the unit is completely recycled and never escapes the unit. This eliminates the need for constantly heating cool outside air as is necessary with traditional
In a properly designed “ventless” system it is physically impossible for any air (steam) to escape the unit because the intake of the fan must equal the output. The only way air can be forced from
the unit is for additional outside air to be drawn into the system, creating a positive pressure.
In a ventless system the cool air is passed over the heater assembly and injected into the drum creating steam within the unit. The hot, moist air is then drawn from the drum of the unit and passed through the condensing chamber where it is subjected to the cooling effect of the condensing spray, and the water is condensed out of the air and collected.
(The effect is similar to having a glass of ice
water sitting on a table and condensation starts to puddle). The air is then reheated and sent back into the drum to absorb more moisture. This cycle is repeated until all moisture is removed from the air stream.
During the drying cycle water is flowing through the baffle system of the condenser assembly at a minimal rate. This cooling water is collected along with the condensation and pumped out of the system by the washer pump. Below is a sketch of the air flow through a ventless system.
Key: |
|
|
a- Fan motor & heating assembly |
|
|
b- Condensing chamber |
|
|
c- Pump |
|
|
d- Condensation and cooling water discharge | e | |
e- Cooling water inlet | a | |
b
d
|
|
|
|
|
|
| To Drain |
|
|
| c |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||||
|
|
| Width 23.62 inch | ||||||||
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
| |||
Page 4
