EdgeStar TBC50S owner manual Removing the CO2 line and mini keg

Removing the CO2 line and mini keg

Once your mini keg is consumed, you need to shut off the CO2 and remove the keg.

∙Open the compartment located on the right-hand side of the mini kegerator.

∙Shut off the regulator (turn the knob counter-clockwise).

∙Put a container under the dispenser and pour off any remaining beer (this will also relieve some of the pressure in the mini keg).

∙Open the mini kegerator main door and disconnect the CO2 line and beer line.

∙Empty the remaining CO2 from the mini keg with the CO2 releaser as shown:

∙Undo the tap from the mini keg by releasing the catch (on the top of the tap) and pulling it up and out of the mini keg):

∙Rinse the tap out under running water. You should also clean it with a mild detergent solution and rinse it thoroughly.

∙Clean the lines as directed in the under “Cleaning and Maintenance” section.

Note that the optional accessories include a cleaning kit that uses CO2 pressure to force the cleaning solution through the lines. To use this system, fill the cleaning kit half full with your choice of cleaning solution (water mixed with a bit of beer line cleaner, baking soda, or white vinegar), connect it to the unit as if it were a non-pressurized mini keg, and pour out all of the solution. Make sure to rinse the lines again!

EdgeStar Mini Kegerator 10