Select WAN Port
& Session
• Select WAN Port & PPPoE Session – Select the desired WAN port and
PPPoE session from the pull-down menu and click the Select button. The
screen will then show the data for the selected Port/Session. Input the
required data and click Update to save your changes
• PPPoE Session MTU –The Maximum Transmission Unit for the PPPoE
session. The default value is 1492 bytes.
WAN IP Account • User Name – Enter the PPPoE user name assigned by your ISP.
• Password – Enter the PPPoE password assigned by your ISP.
• Verify Password – Re-enter the PPPoE password assigned by your ISP.
Options • Specified Fix IP Address – If you have a fixed IP address, enter if here.
Otherwise, this field should be left at 0.0.0.0.
• Assigned Host Name – This field is used by a Host to uniquely associate
an access concentrator to a particular Host request.
PPPoE Auto
Dialup
• Auto Dialup Connect-on-demand – To enable or disable auto dialup for
a PPPoE connection. If you decide not to use auto dialup or auto
disconnect, then you have to connect/disconnect manually.
• Disconnect After Idle – To decide the timeout for disconnecting when
there is no traffic on the connection. Enter -1 to keep the connection
always alive. Enter 0 to enable 'dial on demand by trigger'.
• Echo Time –To determine how often an Echo request is sent to the
PPPoE server. Normally, leave this setting at its default value.
• Echo Retry –To determine the maximum number times that the Echo
request is allowed to be sent to the PPPoE server until a response is
received. Normally, leave this setting at its default value.
Connection
Status This displays the current connection status for each session.
Page 25