Host Network
Binding
• Bind WAN port/Session – Select Enable if you wish to associate this PC
with a particular PPPoE Session. All traffic for that PC will then use the
selected PPPoE port and session.
• Binding Method – Suppose your PC is bound to WAN1 port, now you are
selecting “Strict Binding”. If WAN1 port is disconnected, your packets cannot
go out through WAN2 port, if WAN2 port is still alive. If you are selecting
“Loose Binding” then when WAN1 port is disconnected, your packets will
automatically go to WAN2, if WAN2 is alive.
• Select WAN Port/Select PPPoE session – If the setting above is Enable,
select the desired Port and Session. Otherwise, ignore these settings.
Note: Multiple PPPoE sessions are defined on the Advanced PPPoE screen.
Host & Group
List This table shows the current bindings.
Routing
This section is only relevant if your LAN has other Routers or Gateways.
• If you don't have other Routers or Gateways on your LAN, you can ignore the Static Routing
page completely.
• If your LAN has other Gateways and Routers, you must configure the Static Routing screen as
described below. You also need to configure the other Routers.
Figure 4-2: Routing
Page 30