28
Getting ready to use the R-44
The R-44 uses an SD memory card.
The SD memory card is sold separately. Visit the Roland website (http://www.roland.com) before making
a purchase. The website provides the most recent information regarding compatibility.
1Confirm that the power is turned off.
If the power is on, turn it off. Press and hold the [POWER] switch on the R-44 to turn power on or off.
2Open the Rubber Flap on the side
of the unit.
3Insert the memory card.
931 * When inserting the SD memory card, make
sure the front of the card is facing up and
insert the card slowly. If the card is forcibly
inserted incorrectly, the R-44 or the SD
memory card may be damaged. Please
exercise caution.
* Carefully insert the memory card all the
way in until it is firmly in place.
4Close the Rubber Flap.
5Turn power on.
Press and hold down the [POWER] switch to turn on the power.
1Turn off power to the R-44.
2Open the Rubber Flap.
3Lightly push the memory card inward, then release it.
Remove the memory card after it pops out toward you.
* Never insert or remove a memory card while this unit's power is on. Doing so may corrupt the data on the memory card.
Preparing the SD memory card

Inserting the SD memory card

Removing the SD memory card

Rubber Flap
SD memory card

When using a SD memory card with the R-44 for the first time.

When using a SD memory card with the R-44 for the first time, the memory card must be formatted.
Please format the memory card following the procedure in “Formatting and Checking the SD memory
card” (p. 64). “SD Unformatted” is shown when an unformatted memory card is inserted into the R-44.

The SD memory card write protect feature (LOCK)

The contents of the memory card can be protected by sliding the write protect switch
on the side of the memory card to the “LOCK” position. Unlock the write protect
switch to delete data on the card.
Write protect switch
R-44_e_new.book 28 ページ 2008年1月7日 月曜日 午後5時8分