SMARTNET/SMARTZONE FEATURES
39
the call back tone (four beeps) is heard and your radio automatically
starts transmitting. Press the PTT switch to continue the call.
•To ignore an incoming call, press the CLR key or wait 20 seconds
until the recurring unit call tone stops sounding. NOTE: If the CLR
key is programmed for the Call function, it will not clear the call.
Private Conversation II Calls
General
Private calls allow you to place a call to a specific mobile unit.
Either the Enhanced Private Conversation™ or Private Conversation II™
modes may be programmed depending on the capabilities of the radio
system. Operation in the Enhanced Private Conversation mode was
described starting on page 36, and operation in the Private Conversation
II mode is described in the following information.
The Private Call option switch is required to place these calls, and
either that switch or the Call Response option switch is required to
receive them. Proceed as follows.
Placing a Private Conversation II Call
This call can be initiated by selecting the unit ID from a call list (list
entry) or by directly entering it using the keypad (direct entry). Direct
entry is available with full keypad (15-key) models only. Proceed as
follows:
List Entry Method
1. With a SMARTNET/SmartZone channel selected, momentarily press
the Private Call option switch. The private call mode is indicated by
“C” in the upper part of the display. The tag (alias) of the last ID called
is displayed if it matches an ID in your call list. Otherwise, the last ID
called is displayed.