MAINTENANCE AND REPAIR
1.Replacing the lamp
a)Disconnect the power before replacing the lamp.
b)Wait until the lamp is cooled down.
c)Pull the stage lock to open the projection stage.
d)Push the lever to open the condenser lens frame. (See fig.3)
e)Remove the defective lamp and replaced it with a new lamp. Adjust the filament to the center of the reflector. (See fig.4)
f)Place the condenser lens frame to original position and close the projection stage.
fig. 3 | fig. 4 |
2.Cleaning and assembling of the Fresnel Lens
Remove the Fresnel Lens to wash with water and detergent. Do not use spirit solvent.
fig. 5
3.To assemble the Fresnel Lens, make sure the “UP” side faced the stage glass. (See fig.5)
6
