Eiki LC-HDT10 instruction manual Service, Remote Control Unit, Does not work

Models: LC-HDT10

1 52
Download 52 pages 12.47 Kb
Page 44
Image 44

APPENDIX

Problem:

Try these Solution

Remote Control Unit

Check batteries.

does not work.

Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.

Make sure you are not too far from a projector when using Remote Control Unit.

 

 

Maximum operating range is 16.4’ (5m).

 

Check transmitted signal mode from Remote Control Unit.

 

(See “SETTING” section on page 37.)

 

 

SERVICE

WARNING: High voltages are used to operate this projector. Do not attempt to open cabinet.

You can often correct operating problems yourself. If a projector fails to work properly, see "TROUBLESHOOT- ING" section on pages 43-44. To correct failure, try "Solutions".

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

The CE Mark is a Directive conformity mark of the European Community (EC).

44

Page 44
Image 44
Eiki LC-HDT10 instruction manual Service, Remote Control Unit, Does not work