Eiki LC-SX4L Connecting Projector, Terminals of Projector, Replacement of Terminal

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 3 terminal slots for expansion to tune to diversity of signals from computers and video equipment. 3-built-in Terminal Slots enable you to arrange desired combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.

NOTE; DVI Terminal can not be used INPUT 3 slot.

3 TERMINAL SLOTS (Factory set)

		DVI			AUDIO		CONTROL PORT
					R	L
						(MONO)
R/Pr	G/Y	B/Pb	H/HV	V		AUDIO	CONTROL PORT
					R	L
						(MONO)
VIDEO/Y	C		S-VIDEO		AUDIO
					R	L
						(MONO)
SERIAL PORT IN		SERIAL PORT OUT			AUDIO OUT		USB
R/C JACK					R	L
RESET						(MONO)

INPUT/OUTPUT

TERMINALS

INPUT 3 INPUT 2 INPUT 1

DVI Terminal

5 BNC Terminal

AV Terminal

REPLACEMENT OF TERMINAL

1

2

Remove 2 Screws on terminal.

Pull out terminal by holding handle.

3	Replace terminal. Insert terminal along Guide to fit Plug
	into Socket.
4	Tighten screws to secure terminal.	Screws

Guide

Socket

Plug

Figure shows HDB 15-PIN terminal (Optional parts).

11