![](/images/new-backgrounds/1123604/123604155x1.webp)
Appendix
Serial Control Interface
This projector provides a function to control and monitor the projector's operations by using the
Format
The command is sent from PC to the projector with the format below;
'C' [Command] 'CR'
Command: two charactors (refer to the command table on next page.
The projector decodes the command and returns the 'ACK' with the format below;
'ACK' 'CR'
Operation
1 | Connect a | |||
PORT on the projector and serial port on the PC. | ||||
| (See p.20) |
|
| |
2 | Launch a communication software provided with PC | |||
| and setup the communication condition as follows: | |||
|
|
|
|
|
|
| Baud rate | : 9600 / 19200 bps |
|
|
| Parity check | : none |
|
|
| Stop bit | : 1 |
|
|
| Flow control | : none |
|
|
| Data bit | : 8 |
|
|
|
|
|
|
✔Note:
•The default of the baud rate is set to 19200 bps. If an error occurs in the communication, change the serial port and the communication speed (baud rate).
3 | Type the command for controlling the projector and |
| then enter the "Enter" key. |
Example
When you want to change the input to INPUT 2, Type 'C' '0' '6' 'Enter'.
✔Note:
•Enter with ASCII
78