Eiki LC-XE10 Part Names and Functions, Terminal, This jack is used to service this projector

Part Names and Functions

Terminal

q w e r t

COMPUTER IN 1	COMPUTER IN 2	/
DVI - I
	SERVICE PORT

	*	USB
MCI		RESET

MONITOR OUT

S - VIDEO

USB

R - AUDIO IN - L (MONO)

VIDEO / Y – Pb/Cb – Pr/Cr

AUDIO IN 1 AUDIO IN 2 AUDIO OUT

(VARIABLE)

Do not press this button. This button is used for optional accessories.

y u i o !0

q COMPUTER IN 1 DVI-I y USB (Series B)

Connect computer output (Digital/Analog DVI-I type) or Multi Card Director (optional) to this terminal. (p17, 18)

wSERVICE PORT

This jack is used to service this projector.

eCOMPUTER IN 2 / MONITOR OUT

This terminal is switchable and can be used as computer input, RGB Scart 21-Pin Video input, or monitor output. Set the terminal up as either Computer input or Monitor output properly before using this terminal. An optional cable is required when using this terminal as RGB Scart 21-Pin Video input.(p17, 18)

(This terminal outputs analog signal from COMPUTER IN 1 DVI-I terminal only when using as Monitor out.)

rAUDIO IN

Connect the audio output from video equipment connected to t or i to this jack. (When the audio output is monaural, connect it to L (MONO) jack.) (p18)

tVIDEO

When operating the connected computer with the remote control, connect USB port of your computer to this connector with a USB cable. (p17)

uUSB (Series A)

Connect the Projector USB key (Optional accessories). (p57)

iS-VIDEO

Connect the S-VIDEO output from video equipment to this jack. (p18)

oAUDIO IN 1 and 2

Connect the audio output (stereo) from a computer or video equipment connected to q or e to these jacks. (p17, 18)

!0AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack. (p17, 18) This terminal outputs sound from AUDIO IN terminal r or o.

Connect the composite video output from video equipment to VIDEO/Y jack or connect component video output from video equipment to VIDEO/Y, Pb/Cb and Pr/Cr jacks.(p18)

*A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.

10