Eiki LC-XM1 Basic Operation, Turning on / OFF the Projector, Turning on the Projector, Green

BASIC OPERATION

TURNING ON / OFF THE PROJECTOR

TURNING ON THE PROJECTOR

1	Complete the peripheral connections (with Computer, VCR, etc.)
	before turning on the projector. (Refer to "CONNECTING TO
	THE PROJECTOR" on Pages 11~13 for connecting that
	equipment.)
2	Connect the projector's AC Power Cord into a wall outlet. The
	LAMP indicator lights RED, and the READY indicator lights
	GREEN.
3	Press the power ON-OFF button on the Remote Control Unit or
	on the Top Control to ON. The LAMP indicator dims, and the

Cooling Fans start to operate. The Preparation Display appears on the screen and the count-down starts. The signal from the source appears after 30 seconds.

30

The Preparation Display disappears after 30 seconds.

	TURNING OFF THE PROJECTOR
1	Press the power ON-OFF button on the Remote Control Unit or
	on the Top Control, and the message "Power off?" appears on
	the screen.
2	Press the power ON-OFF button again to turn off the projector.
	The LAMP indicator lights bright and the READY indicator turns
	off. The Cooling Fans operate for 90 seconds after the projector
	is turned off. (During this "Cooling Down" period, this appliance
	cannot be turned on.)
3	When the projector has cooled down, the READY indicator turns
	to green again and you can turn the projector on. After cooling

down completely, disconnect the AC power cord.

Power off?

The message disappears after 4 seconds.

TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU

TURN THE PROJECTOR ON, WAIT AT LEAST 5

MINUTES BEFORE TURNING IT OFF.

When the Power Management function is ON, the Projector detects the signal interruption and turns the Projection Lamp off automatically. Refer to “Power Management” on page 33.

When the TEMPERATURE WARNING indicator flashes red, the projector is automatically turned off. Wait at least 5 minutes before turning the projector on again.

When the TEMPERATURE WARNING indicator continues to flash, follow procedures below:

1.Press the power ON-OFF button to turn off the projector and disconnect the AC power cord from the AC outlet.

2.Check the air filters for dust accumulation.

3.Clean the Air Filter. (See "AIR FILTER CARE AND CLEANING" section on page 35.)

4.Press the power ON-OFF button to turn it on.

If the TEMPERATURE WARNING indicator should still continue to flash, contact the sales dealer where you purchased this projector or service center.

NOTE: The Cooling Fan may work for cooling while the projector is turned off. When the Cooling Fan is working, TEMPERATURE WARNING INDICATOR flashes red.

19