Eiki LC-XT2 Connecting Projector, Terminals Of Projector, TERMINAL SLOTS Factory set

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity of signals from computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.

NOTE; DVI Terminal can not be used INPUT 3 and INPUT 4 slots.

4 TERMINAL SLOTS (Factory set)

SERIAL PORT IN			DVI			AUDIO	L	CONTROL PORT
						R
						(MONO)
SERIAL PORT OUT		R/Pr	G/Y B/Pb H/HV		V	AUDIO		CONTROL PORT
						R	L
						(MONO)
R/C JACK	USB	VIDEO/Y	C	S-VIDEO		AUDIO
						R	L
						(MONO)
AUDIO OUT						AUDIO		CONTROL PORT
R	L		ANALOG RGB
						R	L
INPUT/OUTPUT	RESET
TERMINALS	(MONO)					(MONO)

INPUT 4 INPUT 3 INPUT 2 INPUT 1

DVI Terminal

5 BNC Terminal

AV Terminal

HDB 15-PIN Terminal

1

2

REPLACEMENT OF TERMINAL

Remove 2 Screws on terminal.

Pull out terminal by holding handle.

3	Replace terminal. Insert terminal along Guide to fit Plug
	into Socket.
4	Tighten screws to secure terminal.	Screws

Guide

Socket

Figure shows HDB 15-PIN terminal.

Plug

11